Riverstone Networks RS 8000 Manuel de l'opérateur Page 64
- Page / 158
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
2-40 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide
Hardware Overview Introduction
The ATM Multi-rate line card uses the following LEDs.
ATM OC-12c Line Card
The ATM OC-12c line card supplies one logical connection, through two physical ports (Link 1 and Link 2). Link 1 is
the working (primary) port and Link 2 is the protecting (backup) port.
Note
Do not try to use Link 2 port for another connection different from Link 1. Link 2
and Link 1 act as redundant ports for APS and are essentially one logical port.
Figure 2-25 shows the front panel of the ATM OC-12c MMF line card.
Figure 2-25 Front panel of ATM OC-12c MMF line card
Table 2-33 LED description for ATM Multi-rate line card
LED Description
PHY Green – indicates that the PHY is operating properly and a link is
established
Amber – indicates that the PHY is inactive due to media errors
Blinking Green – indicates that the PHY has been disabled by
management
Off – indicates no connection
Amber – indicates that the diagnostics have detected a fault
Blinking Green – indicates that the PHY port has been redirected
elsewhere
Per-PHY Rx Green – indicates when the PHY’s transceiver receives packets
Amber – indicates when the PHY’s transceiver receives flow-control
packets
Per-PHY Tx Green – indicates when the PHY’s transceiver transmits packets
Amber – indicates when the PHY’s transceiver transmits flow-control
packets
Link 2Link 1
Link2
Offline
Online
Tx
Rx
ATM-OC-12c-MMFG8M-A12B1-02
Hot
Swap
Link1
- RS 8000/8600 1
- Switch Router 1
- Getting Started Guide 1
- COPYRIGHT NOTICES 2
- RADIACIÓN LÁSER Y CONECTORES 6
- RIVERSTONE NETWORKS, INC 9
- AGREEMENT 9
- RIVERSTONE STANDARD WARRANTY 11
- TABLE OF CONTENTS 15
- LIST OF FIGURES 19
- LIST OF TABLES 21
- 1 ABOUT THIS GUIDE 23
- 2 INTRODUCTION 25
- 2.2 SPECIFICATIONS 26
- Introduction Specifications 27
- 2.3 SOFTWARE OVERVIEW 28
- IP Routing 29
- IP Multicast Routing 29
- IPX Routing 29
- 2.3.9 Web Hosting Features 32
- 2.3.10 Management Platforms 32
- 2.4 HARDWARE OVERVIEW 33
- Switching Fabric 34
- Power supply 34
- 2.4.2 Backplane 35
- 2.4.3 Fan Module 35
- 2.4.4 Control Module 35
- Boot Flash 36
- Memory Module 36
- 100-125~5A 38
- 200-240~3A 38
- 50-60 Hz 38
- 100-125V~ 10A 39
- 200-240V~ 6A 39
- 50/60 Hz 39
- 2.4.6 DC Power Supply 40
- 10/100BASE-TXG8M-HTXA2-08 42
- 87654321 44
- 10/100BASE-TXG8M-HTXB2-16 45
- 100BASE-FXG8M-HFXA1-08 47
- 100Base-FX SFP Line Card 48
- 1000Base-SX Line Card 49
- 1000BASE-SXG8M-GSXB1-02 50
- 1000Base-LX Line Card 52
- 1000Base-LLX Line Card 54
- 1000Base-T Line Card 55
- Multi-Mode Short-Reach 58
- Single-Mode 58
- Long-Reach (70 Km) 58
- ATM Multi-Rate Line Card 63
- ATM OC-12c Line Card 64
- ATM-OC-12c-SMFG8M-A12B9-02 65
- POS OC-3 MMFG8M-PO3B1-04 66
- POS OC-3 SMFG8M-PO3B9-04 66
- POS OC-12c SMFG8M-P12B9-02 68
- G8M-PO3MM-02 69
- POS MPLS OC3 69
- G8M-P12MM-02 70
- POS MPLS OC-12c/STM-4 70
- Quad Serial - CEG8M-SECAC-04 71
- Dual HSSI 73
- G8M-HSIAC-02 73
- CMTS Line Card 75
- DOCSIS CMTSG8M-CMTSNA-6X1 76
- Multi-Rate WAN Line Card 77
- Channelized T3 Line Card 80
- CHANNELIZED T3G8M-CT3BB-02 81
- 18-695-01 82
- Figure 2-44 SRP bridge module 83
- 3 HARDWARE INSTALLATION 87
- 3.3 INSTALLING THE HARDWARE 88
- 3.2 HARDWARE SPECIFICATIONS 88
- Internal Power Supply One 94
- Internal Power Supply Two 94
- RS 8600 DC Power Supply 94
- Card Guides 96
- Circuit Board 96
- Metal Plate 96
- To remove 100
- Make sure WIC is aligned 104
- Insert the WIC through the 104
- (Base Slot) 105
- G8M-SRP-MATE 106
- Insert SFP into ports 107
- 4 INITIAL CONFIGURATION 109
- If the message “ 111
- 4.2.1 CLI Access Modes 112
- CONFIGURATION FILE 114
- 4.5 SETTING UP PASSWORDS 120
- Here is an example: 122
- 4.6 SETTING UP SNMP 123
- 4.6.2 Improving SNMP Security 124
- 4.6.3 Supported MIBs 125
- KRVWQD PH RU,3DGGU! 129
- IDFLOLW\W\SH! 129
- 4.9.1 Fail Over 131
- Software/Hardware Versions 134
- Changing Mastership 134
- Hot-Swapping 134
- 5 MANAGING SOFTWARE 135
- Reboot the RS 139
- Enter the 139
- 5.4 HITLESS SOFTWARE UPGRADE 143
- 5.4.1 Hitless Upgrade Example 144
- 5.5 UPGRADING FPGA CODE 146
- APPENDIX A TROUBLESHOOTING 149
- INFORMATION 151
- Numerics 153
Produits connexes et manuels pour Mise en réseau Riverstone Networks RS 8000
(111 pages)Arecont Vision D4SO Series manuály
Uživatelské manuály a uživatelské příručky pro Bezpečnostní kamery Arecont Vision D4SO Series.
Poskytujeme 1 manuály pdf Arecont Vision D4SO Series ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Commentaires sur ces manuels