Riverstone Networks RS 8000 Manuel de l'opérateur télécharger pdf (Page 36)

2-12 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide

Hardware Overview Introduction

Boot Flash

The Control Module has a boot flash containing the RS’s boot software and configuration files. The system software

image file typically resides on a 32 megabyte PC card, but can also be located on a TFTP server or BootP/TFTP server.

Memory Module

The Control Module uses memory to hold the routing tables and other tables. The Control Module 2 contains 128MB

of memory (in a 128MB DIMM).

The Control Module 3 contains 256MB of memory (in two 128MB DIMMs). You can obtain an RS memory upgrade

kit from Riverstone Networks, Inc. to increase memory in the Control Module 3 to 256MB.

The Control Module 5 contains 512MB of memory (in two 256MB DIMMs). You can obtain an RS memory upgrade

kit from Riverstone Networks, Inc. to increase memory in the Control module 5 to 768 MB.

External Controls and Connections

The Control Module has the following external controls.

•

Reset switch (RST). Use this switch to reboot the RS’s CPU.

•

LEDs that indicate the current status of the RS 8000/8600. Table 2-3 describes the meaning of the

Control Module LEDs

•

PC flash card slots. These slots are used to connect the PC card to the Control Module. The

RS 8000/8600’s operating software image resides on the PC cards, and is loaded by the system at

power-up. More than one software image can reside on the PC cards, this allows for upgrades and

the changing of software versions run by the RS 8000/8600.

Table 2-3 RS 8000/8600 Control Module LEDs

LED Description

OK When this LED is on, the RS 8000/8600 and all ports are functioning correctly.

ERR When this LED is on, a fatal system error has occurred. Activate the RS 8000/8600’s boot

PROM to reboot the system.

HBT This LED flashes when the RS 8000/8600’s boot PROM is active.

DIAG When this LED is on, the RS 8000/8600 is in diagnostic mode. While in diagnostic mode,

several other LEDs on the RS 8000/8600 are active, as well.

Online When lit, this green LED indicates that the module is online and is ready to receive,

process, and send packets if configured to do so.

Offline When lit, this amber LED indicates that the Control Module is offline (powered off) and

is ready for hot swap.

The Offline LED also is lit briefly during a reboot or reset of the RS 8000/8600.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 157 158

Pas de commentaire

Riverstone Networks RS 8000 Manuel de l'opérateur Page 36